1. Our Air suction dent puller is used to repair the auto body damage. It can work by itself and there’s no need to use extra items.
2. It must work with an air compressor. Its air working pressure is about 70~170 PSI (5 bar ~12 bar). For some small dent, 170 PSI is recommended. The pad can work with a dent with round, and smooth surface and the pad will be sucked easily.
3. Moreover, the range of dent must be smaller than the pads.
4. There are the 3LB (1.36 kgs) slidding hammer with brass shut off valve, and the 13″ length inlet hose with 1/4″ air plug.
5. With 1 pcs Adaptor and 10pcs Glue tabs for small damage repair by manual operation.
* 3 pcs PAD (60mm , 120mm , 150mm)
* 1 pcs 13″ length inlet hose
* 1 pcs 1/4″ air plug
* 1 pcs Adaptor with 10pcs Glue tabs
* 2 pcs φ11.2mm*L25.4cm Hot Glue Sticks (just for body repair)
- Just for the auto body dent damage recovery.
- Air suction dent sliding hammer puller; with 3lb (1.36kgs) sliding hammer.
- Comes with one adapter and ten piece of glue tabs, and 2 pcs hot glue sticks for PDR work.
- Connect the air compressor, and the suction pad will form a vacuum power.
- Made in Taiwan with high quality.